Master Sentinel V2 Crystal Chamber Chassis (3D Printed) *STL FILE*

3D printed crystal chamber design for the Master Sentinel V2. Please note this chassis is a DIY orientated design and the end user is responsible for the proper assembly and installation. Listing photos are for display purposes and do not come with any hilt(s)

This is a fully 3D printed design that comes in 4 sections. The chamber section will come printed in one solid item, please refer to the photos for proper placement/location. The chassis comes with a resin printed crystal, along with a small part needed to support the crystal inside the housing, lined up by 4 cutouts.
The upper chassis piece aligns with the corresponding holes and slots on the main body chassis part, (refer to the photos for identification)

This design is fully removable once installed and assembled, make sure to glue the parts in place during installation.

Parts list for install:
-CFX, Proffie, or GHV3 soundboard
-NPXL shortpin hiltside connector (or similar)
-qty.2 1.5mm brass tactile switches (included with chassis print)
-qty.3 single pixel accents (up to 3 can be used, 2 for upper chassis and 1 for crystal chamber)
-ShtokCustomWorx Large Pixel Ring (optional, goes in the housing next to the crystal support)
-removable 18650 button top protected cell (Option 2 Battery Contacts included)
-high amp killswitch
-28mm bass speaker

FULL PARTS KIT includes:
-choice of soundboard
-NPXL V3 assembled shortpin hilt side connector
-qty.3 single pixel accents
-SCW Large Pixel Ring
-high amp killswitch
-KeepPower 18650 3000mah 15A protected cell button top
-28mm X-BASS 4ohm/3W bass speaker