NPXL V4/V3 Longpin 1" Poly Holder Lens

CNC machined polycarbonate holder and lens holder for NPXL V4 and V3 longpin connectors. 
Not compatible for short pin connectors or non NPXL modules.

Two piece threaded design, no screws required.

Holder is 25.4mm or 1" in diameter and 8.75mm in height.

Proper installation requires light sanding of the connector so that it will fit into the base.

Align the pins with the proper holes and press up on the connector so that it pushes through, then screw on the bottom half. 

Press back down onto the pins and it should snap into place below. Use a small amount of glue if necessary to secure the holder.

Allows excellent shine through and diffusion for NPXL LED's.