89Sabers Anakin AOTC ‘AS2’ Install Chassis

3D printed chassis for the 89Sabers AS2 hilt design, not intended for any other model.
Printed in two parts, including a fully removable core and a speaker pod.
The chassis will properly align itself using the switch actuators in the hilt and the speaker pod secures itself in place with the pommel screwed on.
There are two possible locations for switches, allowing up to two switch function. One switch uses a switch/pixel combo in one of the shine through locations on the emitter and the other switch location is on the upper emitter box section. You must use at least one of these.

Parts list for install:
-CFX, Proffie, GHV4
-qty.1 SCW Pixel Tactile switch (included with chassis print)
-qty.1 1.5mm brass tactile switch (included with chassis print)
-NPXL shortpin hiltside connector (V4 or ECO compatible)
-removable 18650 protected button top cell (Option 2 battery contacts included with chassis print)
-high amp killswitch
-SPKR PCB set (required for speaker pod use)
-28mm bass speaker

FULL PARTS KIT includes:
-CFX, ProffieV3.9 or GHV4
-unassembled NPXL V4 shortpin hiltside connector
-removable KeepPower 18650 3500mah 15A protected button top cell
-high amp killswitch
-SPKR PCB set
-28mm X-BASS 4ohm/3W bass speaker