Creepy Uncle V4 (2024 Version) Crystal Chamber Install Chassis

3D printed crystal chamber install chassis designed specifically for the newest version of the Creepy Uncle from Denis Lukyanov (2024 release).
Please note this design will not be compatible with any other hilt or version of this hilt.
Printed in separate parts, includes two main items and small parts for the inner grenade section, emitter section, and control box.
Pictures shown with additional electronics are for demo purposes only, this listing does not come fully installed and you are required to do your own installation or source a third party installer.

This design requires a ProffieV3.9 for easy USB port access, either through a standard USB-C port or a ShtokCustomWorx USB port.
Only compatible with the non helper board control box setup, for killswitch control box access.

Parts list required for install:
-ProffieV3.9 soundboard
-qty.1 NPXL shortpin hiltside connector (or similar)
-qty.1 thin neck PCB set
-Power/Speaker PCB connector set (LARGER standard size, NOT the 17.5mm version)
-high amp killswitch (optional)
-USB C port or ShtokCustomWorx USB port
-removable 18650 protected button top battery(Option 2 battery contacts included with chassis)
-28mm bass speaker
-single pixel accent LED for crystal chamber
-qty.2 6x3x4.3mm tactile switch (included with chassis)
-red and green 3mm accent LED's (included with chassis, optional for install)
-68ohm resistor for red accent LED (included with chassis)
-4mm brass tube for wire channel passageway(optional and not required)

FULL PARTS KIT includes:
-Choice of soundboard: CFX,ProffieV3.9 or GHV3
-qty. 1 unassembled NPXL V4 shortpin hiltside connector
-qty.1 unassembled Thin Neck PCB set
-qty.1 unassembled Power/Speaker PCB connector
-high amp killswitch
-removable KeepPower 18650 3000mah 15A protected button top cell
-28mm X-BASS 4ohm/3W bass speaker
-switches, accent LED's and resistor needed for control box wiring
-single pixel accent LED
-ShtokCustomWorx USB data/charging port