KR Sabers ‘5pectre Five’ Sabine Wren Install Chassis

3D printed basic install chassis for the KR Sabers '5pectre Five' saber design.
Not compatible with any other saber design other than this specific one.
Printed in two parts, an emitter PCB holder, and a removable main body section.
*Please note that example photos are for listing purposes/example only, this does not come fully installed with electronics, other colors are available for purchase*

This chassis offers up to 3 switch operation to use in conjunction with this saber's 3 way actuator. Not all 3 switches have to be used with this design if it is not required.
It is highly recommend that the vertically placed tactile switches be glued in place first after wiring to test before final assembly.

The emitter printed part inserts through the top of the emitter and is held in place by the hidden retention screw on the thin neck's threading.
The main chassis is accessed and removed by removing the pommel, sliding through the hilt body and aligning with the actuator; the chassis will not insert all the way unless properly aligned.

Parts list for install:
-CFX, Proffie, or GHV3 soundboard
-NPXL shortpin hilt side connector (V3 or ECO compatible)
-Thin Neck PCB connector set
-removable 18650 button top protected cell battery (uses OPTION 2 battery contacts, included with the chassis)
-high amp killswitch
-22mm speaker
-up to three 1.9mm brass tactile switches (included with chassis)

FULL PARTS LIST includes:
-choice of soundboard (CFX, ProffieV3.9, or GHV3)
-qty.1 NPXL V3 unassembled hilt side connector
-qty.1 unassembled Thin Neck PCB connector set
-qty.1 KeepPower 18650 3000mah 15A protected button top cell
-qty.1 high amp killswitch
-qty.1 Veco 22mm 4ohm/3W bass speaker