ELF Sabers Shin Hati DIY Install Chassis

3D printed install chassis designed for the ELF Sabers Shin Hati saber. This is not designed for any other version of this hilt.
Printed in a single removable chassis design, this chassis comes in two size variations, one for a fuller longer design for 22mm speakers, and a more compact design for a 28mm speaker use.

Please note that the shorter compact design is only designed for Proffie because of the small size.
All example photos are for listing purposes only, this chassis does NOT come fully installed with any electronics. Installation is required by the end user.

This chassis is inserted from the opening below the painted grip section after removing the pommel, with the two offset switch channels lining up appropriately with the hilt switch plungers.

Parts list for install:
(For standard longer version)
-CFX, Proffie, or GHV3
-NPXL shortpin hiltside connector (V3 or ECO compatible)
-two brass 1.5mm tactile switches (included with chassis print)
-removable 18650 button top protected cell (Option 2 battery contacts included with print)
-high amp killswitch
-22mm speaker

(For shorter compact version)
-Proffie board only
-NPXL shortpin hiltside connector (V3 or ECO compatible)
-two brass 1.5mm tactile switches (included with chassis print)
-removable 18650 button top protected cell (Option 2 battery contacts included with print)
-28mm bass speaker

FULL PARTS KIT includes:
(For standard longer version)
-choice of soundboard (CFX, ProffieV3.9, or GHV3
-unassembled NPXL V3 shortpin hilt side connector
-KeepPower 18650 3000mah 15A button top protected cell
-high amp killswitch
-22mm Veco 4ohm/3W bass speaker

(For shorter compact version)
-ProffieV3.9
-unassembled NPXL V3 shortpin hilt side connector
-KeepPower 18650 3000mah 15A button top protected cell
-28mm X-BASS 4ohm/3W bass speaker